Bobcat S150 P0340 Error Code

P0340 Fault Code Meaning :

Engine Speed Sensor No Signal

Camshaft position sensor fault

CAM Signal Fault

Cam Sensor Signal Fault

P0340 Error Code

Cam Sensor Signal Fault is the main cause of P0340 error.The condenser converts gases into liquids, which expels heat from your rig. Materials can build up over time, causing a layer of dirt and grime to form on the condenser's coils. Your AC system will only blow hot air since the refrigerant fails to cool down.

Tip For S150 Model

When an engine is running in an enclosed area, fresh air must be added to avoid concentration of exhaust fumes. If the engine is stationary, vent the exhaust outside. Exhaust fumes contain odorless, invisible gases which can kill without warning.

Do not engage the starter for longer than 15 seconds at a time. Longer use can damage the starter by overheating. Allow starter to cool for one minute before using starter again.